• : 48103128 , 3198619127
  • : 086-632-5115110 , 086-632-5115112
  • : info@makemachinetools.com

MAKE

    Home > News >

Zaozhuang Make Machinery shearing machine use precautions

Zaozhuang Make Machinery Co.,Ltd.shearing machine use precautions

1. Start the plate shearing machine to run idle for several cycles to ensure that under normal conditions, the plates with different thicknesses can be cut from thin to thick. Ensure that the user is familiar with the performance of the shear.

2. The blade clearance must be adjusted when the thickness of the plate is different. If the corresponding blade clearance is not adjusted, the blade durability will be affected.

3. Switch on the pressure gauge switch in the shearing process, observe the oil pressure value, and the pressure should be less than 20MPa when cutting 12mm plate. The remote pressure regulating valve No9 is set at 20-22mpa when leaving the factory. The user must abide by this regulation. It is not allowed to increase the pressure for the shear exceeding the specified material surface and cause damage to the machine.

4. Sound balance during operation. If there is noise in the shearing machine, stop the machine for inspection.

5. When the shearing machine is operating, the temperature of the oil tank is increased to less than 60 degrees, and it will be shut down for rest.

Zaozhuang Make Machinery Co., Ltd. adhering to the purpose of customer service, to provide customers with good products and services!

Welcome to consult!

(Responsible editor:admin)
TOP